The glass point holder for aesthetic fixing of single layered glass façade panels.
Fordele
The geometry of the anchor requires only a small drill hole diameter, allowing for a discreet and visually attractive fixing solution.
There is no need to drill through the glass façade panel to install the anchor. This adds more safety. The fastening point remains inside the façade panels and does not penetrate through to the outside. This reduces the danger of contamination and ensures a good seal.
Create an undercut drill hole and chamfer the edge of the drill hole in one work step.
The glass point holder with for aesthetic fixing of laminated composite safety glass in suspended, back-ventilated façades.
Anvendelse og godkendelse
Applikationer
Exterior façades
Interior façades
Glass façades
Byggematerialer
Single layer safety glass (≥10mm)
Glass ceramic (≥10mm)
Du kan finde detaljeret information om byggematerialer i registreringsdokumentet.
Monteringsvejledning
Funktionsmåde
Before glass hardening: use wet diamond drilling - first cylindrical, then conical - to drill an undercut hole.
After drilling the glass, the glass must be hardened before the undercut anchors can be set.
When the undercut anchor is set, an optimal, positive-locking connection is created between the expanding part and the drill hole.
